Hardware humbug

[unixronin]

To summarize the underlying problem, babylon5's Linux install is ancient and clogged with cruft, and its SCSI hard disks are dying rapidly.

Simple solution:  Install an inexpensive SATA controller and a new mirrored pair of SATA disks.

Well, by swapping controllers around so that the existing SCSI disks aren't the first devices, I can get the machine — which is built on an Asus A7V333 motherboard — to boot from a SCSI CDROM which it will not, as a general matter of course, condescend to boot from.  From that CDROM I can boot a Gentoo liveCD, set up the new disk, install Gentoo, build a kernel, set up grub, etc, etc, etc, all with relatively little issue (aside from the part where I typo'd "-mtune=athlon-xp" as "-mtune=athlonxp" which resulted in gcc declining to compile anything).

There's just one problem.  Try as I might, this motherboard WILL NOT boot from SATA.  Leaving me squarely behind the eight ball for upgrading the machine, I think, unless I hold my nose and suffer with PATA.  It'd be cheaper to buy a new motherboard, CPU and RAM than to buy a pair of new SCSI disks.

(Update 2355:  I didn't even have much luck with PATA so far.  I even tried dropping in my one good spare PATA disk, an 80GB Seagate Barracuda of uncertain age, just to put a bootloader on its MBR to boot the SATA disk. No joy; grub would install but wouldn't load.)

Comments

[tomatoe333.livejournal.com]

Sil? Hmmm, I remember those being REALLY crappy controllers...

If there is an on-board BIOS/firmware, get into that, and tell it that one of the SATA drives is drive C:. That'll get it to be bootable.

If there is no BIOS/firmware, therein lies the problem.

[unixronin.livejournal.com]

Firmware in the SiI3124? Hmm ..... that possibility hadn't occurred to me. I may be able to do that.

(Update: No, the 3124 does have onboard firmware, but it can't do that ... it's solely for setting up RAID configurations.)